adhesive friction
英
美
[网络] 黏著摩擦
双语例句
- The results showed that for the material without graphite, the main wear mechanism was adhesive, the friction coefficient(μ) and wear rate(△ W) were larger;
结果表明：不含石墨时，材料的摩擦系数和磨损率均较大，磨损主要为粘着磨损； - Adhesive friction and Transporting Safety
附着摩擦与运输安全性 - The main wear mechanisms of nylon 1010 composites are fatigue fracture and adhesive wear and it can be observed that the GF is rubbed, fractured and peeled off under dry friction condition.
干摩擦下的复合材料磨损以疲劳断裂和粘着为主，且纤维出现磨损、断裂及从基体中剥落的现象。 - Thermal shock cracking in friction surface, over heated and over burned microstructure in sub surface, adhesive element diffusion from surface to center occur due to friction heat. Layer delamination occurs also on the worn surface of the steel.
因摩擦热的影响，制动后钢的摩擦表面出现热震开裂，表层组织过热甚至过烧，表面的粘着物由表向里扩散； - Near the latter point, the strain velocity of adhesive friction and that of slide friction is near to be equal and friction coefficient has almost no effect to the strain velocity with slide friction.
在轧件与轧辊分离处，变形速度为零，在这点附近粘着摩擦和滑动摩擦变形速度值接近相等，摩擦系数几乎不影响滑动摩擦情况下的变形速度。 - The results show that samples have self-lubricity after copper deposition. The surface modification method can control inherent adhesive wear of pure Ti to an extent, which can reduce wear and friction coefficient.
结果表明：复合铜之后的试样具有一定自润滑性，这种表面改性方法使纯钛固有的黏着磨损得到了一定的控制，减小磨损，降低了摩擦因数。 - Using friction coefficient tester, we have investigated the humility and UV-light dependence of the adhesive force and friction coefficient on glass surface and nano-TiO 2 film coated glass surfaces in the relative humidity of 30%~ 70%.
在30%～70%的相对湿度范围，使用摩擦系数测定仪，研究了玻璃表面和玻璃基体上纳米二氧化钛光致双亲性膜的摩擦系数与紫外光和环境湿度的变化规律。 - It provides theoretical foundation for determining the size of pressing load. Finally, a fractal model of adhesive friction coefficient is proposed by comparing the normal elastic load with the normal plastic load acting on particle contact points.
最后，通过比较作用于颗粒接触点的法向弹塑性载荷，提出了粘着摩擦系数的分形模型。 - The cause of adhesive wear of plunger-cylinder wall friction pair in axial plunger pump and its solution
轴向柱塞泵柱塞&缸孔摩擦副粘着磨损原因及解决办法 - Friction characteristics of PC and its alloys can be explained by adhesive friction theory, and wear of these materials are controlled by adhesive, abrasive and fatigue wear mechanisms.
聚合物及其合金的摩擦特性可由粘着摩擦理论解释，其磨损过程主要受粘着、磨粒和疲劳机理控制。